IAC Baghouse Dust Collector Conversions, Refurbishments, and Rebuilds

IAC_OEM_BD_BAGHOUSE_CONVERSIONS_LOW-RATIO

IF YOUR CAPITAL BUDGET HAS YOU STRAPPED, CONSIDER A CONVERSION OR REBUILD IN PLACE OF A TOTALLY NEW BAGHOUSE DUST COLLECTOR.

Baghouse dust collectors can often be rebuilt or upgraded at a lower cost over installation of new collectors. The dust collection efficiency of antiquated reverse air and shaker designs can also be improved with efficient pulse jet cleaning, typically increasing the amount of gas volume the baghouse dust collector can clean without increasing its size. Side walls, hoppers, and ductwork is reused in the conversion, and a new “clean air plenum” with bags and cages is supplied.

Watch a video on baghouse conversions

SAVINGS

Savings occur not only from reduced equipment. Rebuilding typically reduces demolition, support concrete, new electrical cabling, crane time and labor. A properly organized conversion can also minimize plant downtime over new systems.

As a full-service OEM of dust collection systems, IAC has the engineering staff to design the baghouse dust collector, fabricate the unit, manage the project, and provide the on-site construction and installation service. Our fabrication facilities, located just minutes from our corporate office, allow us to efficiently manage your project and keep a close eye on the production time and quality control processes of your capital equipment.SAVINGS

Remote monitoring of dust collectors without climbing ladders

Stop climbing to get readings!


Our Smart Plant™ Remote Monitoring Systems empower you to manage your plant process equipment from anywhere.

REACH OUT &

GET STARTED TODAY

If you think rebuilding might make sense for you, contact us for a free project analysis and budgetary proposal

Additional Services

See examples of the M-Pulse Baghouse in our Industries Served section.